HOME  »  Engine Build Day 1  (9 Slides)     [Page 1 of 1] :: Jump To  
  Up one level  
DCP04831 * First question we had to ask was where did the trust washers go.
None of the manuals clearly showed the solution. So we looked to my other engine for the answer.
They go on both sides. * 1152 x 864 * (290KB)
DCP04832 * We checked the specs for the trust bearings. 6.5 in 3 different spots, so were within spec using stock thrust bearings. * 1152 x 864 * (238KB)
DCP04836 * We got the front plate on and the camshaft. Problems started when I realized I did not have a rear oil seal.
On the pistons. Which side should I use. This way or? * 1152 x 864 * (214KB)
  DCP04831  
  DCP04832  
  DCP04836  
DCP04837 * This way? Which way should the 060 point? * 1152 x 864 * (229KB)
DCP04838 * In the manual it says the
DCP04839 * 060 * 1152 x 864 * (212KB)
  DCP04837  
  DCP04838  
  DCP04839  
DCP04840 * Once I sort out the direction of the pistons, I'll assemble them and keep moving. Ordering parts in the morning. * 1152 x 864 * (209KB)
DCP04841 * Progress, the cam spins well, same with the crank. * 1152 x 864 * (202KB)
DCP04842 * Con rods waiting for duty. Thanks Bob for the help. * 1152 x 864 * (218KB)
  DCP04840  
  DCP04841  
  DCP04842  
Album last updated on Nov 03, 2005 - 10:51 PM
Powered by JAlbum 5.2 and BluPlusPlus skin
justdrive.ca